subject
Biology, 21.11.2020 05:50 TheOneWhoSucksAtMeth

What is the secondary level of structure in proteins?

ansver
Answers: 3

Other questions on the subject: Biology

image
Biology, 22.06.2019 02:00, Yskdl
Consider the motion of the balloon and its air contents in terms of momentum. in step 1 above, the total momentum of the balloon and its contents was zero. recall that momentum = mv. both the balloon and the air inside it had a velocity of zero and therefore the total momentum was zero. now think about what happened when the air escaped from the balloon. a certain mass of air accelerated in one direction. in order to keep the total momentum of the system zero, the balloon itself (which has mass) had to accelerate in the opposite direction. use this scenario to you explain why the soda can rotates when the water squirts out of the escape holes. what was your hypothesis concerning the water-filled can? according to your data, do you think your hypothesis was correct? (be sure to refer to your data when answering this question.) summarize any difficulties or problems you had in performing the experiment that might have affected the results. describe how you might change the procedure to avoid these problems. give at least one more example of newton's third law in everyday life.
Answers: 1
image
Biology, 22.06.2019 04:30, emilysambrano2
This part insulates the reaction chamber from the transfer of heat to or from the surrounding environment
Answers: 1
image
Biology, 22.06.2019 06:40, ethanmel21
The steps in the formation of extrusive igneous rocks are listed below in an incorrect order: 1. rock melts due to high temperature. 2. rock is buried deep under earth's surface. 3. magma is forced out of earth's surface during volcanic eruption. 4. lava cools and crystallizes to igneous rock. which of these best shows the correct order of steps in the formation of extrusive igneous rocks? 1, 3, 4, 2 2, 1, 3, 4 3, 4, 2, 1 4, 2, 1, 3
Answers: 3
image
Biology, 22.06.2019 15:20, ashley232323
Suppose a particular species of tulip plant has three alleles for the gene that codes for flower color. the cr allele produces red tulips, the cp allele produces purple tulips, and the cw allele produces white tulips. cr is dominant over cp and cw, and cp is dominant over cw. for each of the following crosses, determine the expected ratio of offspring for each flower color. cr cp x cp cw cr cw x cp cw 1 red: 1 purple : 0 white, 1 red: 2 purple: 1 white, 2 red: 1 purple 1 white, 1 red: 3 purple : 0 white, 2 red: 0 purple : 2 white, 2 red: 2 purple : 0 white
Answers: 2
You know the right answer?
What is the secondary level of structure in proteins?...

Questions in other subjects:

Konu
Mathematics, 29.09.2019 23:50